AC GUITAR SIMULATOR
Makes an electric guitar sound like an acoustic one.
What it does
AC GUITAR SIMULATOR gives your electric guitar the tonal character of an acoustic: a bright attack and a hollow body sound. You set BODY, LOW and HIGH and choose the volume.
How to use it
- Play chords with a clean sound for an acoustic-sounding rhythm guitar.
- Use it for a pickup sound that feels more natural on a recording.
- Raise HIGH for a fresh, shining strum.
- Combine it with chorus or reverb for a more spacious tone.
Where it goes in the chain
Put AC GUITAR SIMULATOR early in the chain, before reverb or delay, and with no overdrive before it, so the signal stays clean.
Starting points
Warm acoustic
BODY 55 · LOW 55 · HIGH 45 · LEVEL 50
A soft, round tone for chords.
Bright strum
BODY 50 · LOW 40 · HIGH 65 · LEVEL 50
A fresh tone with plenty of shine.
Every setting
| Setting | Range | What it does |
|---|---|---|
| BODY | 0 to 100 | Adjusts the body resonance. Higher sounds fuller and more hollow, lower drier. |
| LOW | 0 to 100 | The amount of low tones. Higher gives a warmer, fuller base, lower a thinner sound. |
| HIGH | 0 to 100 | The amount of high tones. Higher sounds brighter and fresher, lower softer. |
| LEVEL | 0 to 100 | The volume of the effect. Set it so your sound does not get louder or softer when you switch it on. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. AC GUITAR SIMULATOR in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, AC GUITAR SIMULATOR is a device in your rack, with all its controls on the front.