BASS PITCH SHIFTER bass
Shifts the pitch of your bass, with your clean bass kept in.
The version for guitar: PITCH SHIFTER
What it does
The pitch shifter changes the pitch of your bass by a number of semitones, up to two octaves up or down. You can make one or two voices and detune them slightly for a thicker sound.
DIRECT LEVEL keeps your own note fully in the sound, so the root stays firm.
How to use it
- Set a voice an octave lower (-12) for extra weight under your note.
- Use two voices with FINE slightly up and down for a thick, gently floating bass.
- Set a voice to +7 or +12 for a solo or a melody.
- Choose a slower MODE for less waver, or FAST for the quickest response.
Where it goes in the chain
Put it early in the chain, after a compressor and before drive and amp. A clean signal gives the best pitch tracking.
Starting points
Octave below
VOICE 1 VOICE · 1: PITCH -12 · 1: FINE 0 · 1: MODE MONO · DIRECT LEVEL 100
A tight extra voice under your note.
Fat chorus bass
VOICE 2 STEREO · 1: PITCH 0 · 1: FINE 10 · 2: PITCH 0 · 2: FINE -10 · DIRECT LEVEL 100
Two slightly detuned voices left and right for a wide bass.
Every setting
| Setting | Range | What it does |
|---|---|---|
| VOICE | 1 VOICE / 2 MONO / 2 STEREO | The number of voices. 1 VOICE is one voice, 2 MONO is two voices together in the centre, 2 STEREO spreads them over left and right. |
| 1: PITCH 2: PITCH | -24 to 24 | The shift of voice 1 and 2 in semitones. -12 is an octave lower, +12 an octave higher. |
| 1: FINE 2: FINE | -50 to 50 | Fine adjustment of the interval. Small values give a floating, thicker sound, large ones sound out of tune. The full FINE range equals one PITCH step. |
| 1: MODE 2: MODE | FAST / MEDIUM / SLOW / MONO | Picks response and modulation. FAST responds fastest, then MEDIUM and SLOW. The slower, the less the sound wavers. MONO is a separate setting. |
| 1: PRE-DELAY 2: PRE-DELAY | 0ms / 1ms / 2ms / 3ms … 1/1D / 2/1 (319 steps) | Delays voice 1 and 2 a little, in milliseconds or a note value. 0ms sounds direct, longer gives a real second instrument. |
| 1: FEEDBACK | 0 to 100 | Sets the feedback of the pitch-shifted sound. Higher gives more repeats. |
| 1: LEVEL 2: LEVEL | 0 to 100 | The volume of voice 1 and 2. Lower keeps the voice in the background, higher makes it as clear as your own note. |
| DIRECT LEVEL | 0 to 100 | The volume of your clean bass next to the voices. At 100 the root stays complete, so the low end stays firm. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS PITCH SHIFTER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, BASS PITCH SHIFTER is a device in your rack, with all its controls on the front.