POLY OCTAVE
Adds a note an octave below, chords included.
What it does
POLY OCTAVE adds a note one octave below what you play, and it also works on chords. The sound gets deeper and fuller, even when you play several notes at once.
You blend the lower octave in with OCTAVE LEVEL and keep your own tone with DIRECT LEVEL.
How to use it
- Play chords with a little OCTAVE LEVEL for a bigger, deeper sound.
- Push the octave up in the mix for a heavy, organ-like layer under a solo.
- Use it in a verse for extra size without playing harder.
- Change RANGE to choose in which register the octave is added.
Where it goes in the chain
Put POLY OCTAVE early in the chain, before the overdrive or the amp. That way the extra octave is distorted along with your tone.
Starting points
Depth on chords
OCTAVE LEVEL 35 · DIRECT LEVEL 100
Chords sound deeper and fuller, without the effect standing out.
Heavy layer
OCTAVE LEVEL 80 · DIRECT LEVEL 70
The lower octave is clearly audible and gives a full, heavy sound.
Every setting
| Setting | Range | What it does |
|---|---|---|
| RANGE | 0 to 100 | Selects the register the effect works on. Turn it and listen: pick the value where the lower octave sounds cleanest. |
| OCTAVE LEVEL | 0 to 100 | Volume of the note one octave below. Low adds a little depth, high gives a clear lower second voice. |
| DIRECT LEVEL | 0 to 100 | Volume of your normal sound. At 100 your own tone stays up front, lower puts more weight on the lower octave. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. POLY OCTAVE in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, POLY OCTAVE is a device in your rack, with all its controls on the front.