S-BEND
A pitch bend on command with a single switch, no pedal needed.
There is a version for bass too: BASS S-BEND
What it does
S-BEND bends your note up or down with a single switch and lets it return. You do not need an expression pedal.
PITCH sets how many octaves the bend covers, RISE TIME and FALL TIME set how fast the note goes up and comes back.
How to use it
- Switch TRIGGER from OFF to ON for a bend, for example at the end of a phrase.
- Choose +1 OCT for a small upward bend, +4 OCT for an extreme siren.
- Choose a negative PITCH for a falling note, like a record slowing down.
- Raise FALL TIME for a calm return, or lower it for a sharp snap.
Where it goes in the chain
Put S-BEND early in the chain, before the overdrive or the amp, so the bent note is distorted along with it.
Starting points
Rising siren
TRIGGER ON · PITCH +2 OCT · RISE TIME 50 · FALL TIME 5
The note shoots up and snaps back quickly.
Falling note
TRIGGER ON · PITCH -2 OCT · RISE TIME 60 · FALL TIME 20
The note sinks slowly and returns gently.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TRIGGER | OFF / ON | Starts the bend when you switch it from OFF to ON. A memory always stores it as OFF. |
| PITCH | -3 OCT / -2 OCT / -1 OCT / +1 OCT / +2 OCT / +3 OCT / +4 OCT | The range of the bend, from 3 octaves down to 4 octaves up. Choose an upward setting for a rising note, a downward one for a falling note. |
| RISE TIME | 0 to 100 | How long the note takes to reach the full bend. Low is fast and sharp, high is slow and gliding. |
| FALL TIME | 0 to 100 | How long the note takes to return to the original pitch. Low is a quick snap back, high a long glide back. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. S-BEND in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, S-BEND is a device in your rack, with all its controls on the front.