PITCH SHIFTER
Shifts your pitch up or down, with one or two voices.
There is a version for bass too: BASS PITCH SHIFTER
What it does
PITCH SHIFTER moves your note a number of semitones up or down, by as much as two octaves. You can run one or two voices. A small FINE detune gives a thicker, almost chorus-like sound.
Large steps give an octave effect or a second voice.
How to use it
- Set 1: PITCH to -12 for an octave down, or +12 for an octave up.
- Use two voices with a slight FINE detune (for example +10 and -10) for a wide, double-tracked sound.
- Choose 2 STEREO to spread the two voices across left and right.
- Set PITCH to a fifth or a fourth for a simple second voice.
Where it goes in the chain
Put PITCH SHIFTER before the overdrive or amp for the clearest tracking. After the amp also works, for an effect on the final sound.
Starting points
Double-tracked
VOICE 2 STEREO · 1: PITCH 0 · 1: FINE 12 · 2: PITCH 0 · 2: FINE -12 · 1: LEVEL 70 · 2: LEVEL 70
Two slightly detuned voices make your guitar wider.
Octave up
VOICE 1 VOICE · 1: PITCH 12 · 1: FINE 0 · 1: LEVEL 60 · DIRECT LEVEL 100
A bright octave voice above your own tone.
Every setting
| Setting | Range | What it does |
|---|---|---|
| VOICE | 1 VOICE / 2 MONO / 2 STEREO | Number of voices: 1 VOICE, 2 MONO (both voices together) or 2 STEREO (two voices left and right). |
| 1: PITCH 2: PITCH | -24 to 24 | Shift in semitones, from 24 down to 24 up. 12 is an octave, 7 a fifth, 0 is no shift. |
| 1: FINE 2: FINE | -50 to 50 | Small detune on top of PITCH: FINE 100 would equal one semitone. A few points give width and a double-tracked feel, the maximum is half a semitone. |
| 1: MODE 2: MODE not verified | FAST / MEDIUM / SLOW / MONO | Chooses the response: FAST, MEDIUM or SLOW. Slower settings respond later but add less modulation to the pitch. Try each on your own playing. |
| 1: PRE-DELAY 2: PRE-DELAY | 0ms / 1ms / 2ms / 3ms … 1/1D / 2/1 (319 steps) | Time between your direct sound and the shifted sound. Normally leave it at 0 ms. A note value follows the tempo of the memory. |
| 1: FEEDBACK | 0 to 100 | How much of the shifted sound is fed back. Low for a light tail, high for longer repeats. |
| 1: LEVEL 2: LEVEL | 0 to 100 | Volume of the shifted voice. Higher for a clear second sound, lower for something subtle. |
| DIRECT LEVEL | 0 to 100 | Volume of your normal sound. At 100 your own tone stays up front. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PITCH SHIFTER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, PITCH SHIFTER is a device in your rack, with all its controls on the front.