PHASER

A rotating, rolling swirl that moves through the sound.

There is a version for bass too: BASS PHASER

What it does

PHASER sends your sound through a series of filters that move up and down. This creates a rotating swirl that is softer than a flanger and less metallic.

With more STAGE the effect sounds richer and deeper. With more RESONANCE the movement becomes sharper and fuller.

How to use it

  • Set a slow RATE and low RESONANCE for a soft, floating clean tone.
  • Set RESONANCE higher and choose 8 STAGE for a clear, rotating solo.
  • Use STEP RATE to make the rate and depth change in steps.
  • Put it before an overdrive for a rotating tone with plenty of gain.

Where it goes in the chain

Usually before the amp or before the overdrive. After the amp it sounds smoother. Always before delay and reverb.

Starting points

Soft float

STAGE 4 STAGE · RATE 20 · DEPTH 50 · RESONANCE 20

A light, slow rotation under a clean tone.

Full rotation

STAGE 8 STAGE · RATE 35 · DEPTH 80 · RESONANCE 50

A clear, rich phaser for chords or a solo.

Deep 12 stage

STAGE 12 STAGE · RATE 15 · DEPTH 70 · RESONANCE 40

A slow, wide rotation with plenty of depth.

Every setting

SettingRangeWhat it does
STAGE4 STAGE / 8 STAGE / 12 STAGEThe number of filter steps. More steps give a richer, deeper effect with more waves. 4 STAGE sounds airy, 12 STAGE sounds full.
RATE0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps)The speed of the rotation: a number from 0 to 100, or a note value such as 1/4 or 1/8D, which follows the tempo (BPM) of the memory.
DEPTH0 to 100How far the movement reaches. Low is subtle, high pulls the tone clearly through the frequency range.
RESONANCE0 to 100Feeds part of the effect back in. Higher sounds sharper and nasal, lower sounds softer and more natural.
MANUAL0 to 100The center frequency at which the phaser works. Lower sounds deeper and darker, higher sounds brighter.
STEP RATEOFF / 0 / 1 / 2 … 1/16T / 1/32 (120 steps)Sets the cycle of the step function, which makes the rate and depth change in steps. Higher gives finer changes. OFF leaves the step function out.
EFFECT LEVEL0 to 100The volume of the phaser signal in the mix. Higher gives more swirl, lower lets your own tone lead.
DIRECT MIX0 to 100The volume of the dry signal added to the mix. At 0 you hear mostly the effect, higher lets more of your normal tone through.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PHASER in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, PHASER is a device in your rack, with all its controls on the front.

Download for Mac