BASS CHORUS bass
A swirl that makes your bass sound wider without taking away the low end.
The version for guitar: CHORUS
What it does
Chorus lays a slightly detuned copy over your bass and moves it slowly back and forth. The sound gets wider and softer. On bass it works best with a LOW CUT that keeps the lowest notes out of the effect, so they do not start to wobble.
DIRECT LEVEL sets how much of your untouched bass stays in the sound.
How to use it
- Set RATE slow and DEPTH low for a clean bass that sounds wider, without anyone noticing an effect.
- Use the STEREO type for a wide, moving tone in ballads and jazz.
- Keep DIRECT LEVEL at 100 and LOW CUT high enough, so the low end stays firm and the movement lives in the mids and highs.
- Set RATE faster and DEPTH higher for a clear, wobbly bass in funk and pop.
Where it goes in the chain
Put it after compressor and drive and before delay and reverb. That keeps the distortion tight and the space behind it clean.
Starting points
Subtle widening
TYPE STEREO · RATE 20 · DEPTH 30 · EFFECT LEVEL 60
A clean bass that sounds just a little roomier.
Clear swirl
TYPE MONO · RATE 45 · DEPTH 60 · EFFECT LEVEL 80
An audible effect for funk and pop, with a tight bottom end.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | MONO / STEREO | MONO gives one effect signal and stays in the centre. STEREO spreads it over left and right for a wider picture. |
| RATE | 0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps) | The speed of the swirl, free or as a note value. Slow is calm, fast sounds like a vibrating effect. |
| DEPTH | 0 to 100 | How far the pitch moves back and forth. Low is subtle, high sounds seasick and wobbly. |
| EFFECT LEVEL | 0 to 100 | How much of the chorus sound you hear. At 100 it is full, lower makes it milder. |
| LOW CUT | FLAT / 20.0Hz / 25.0Hz / 31.5Hz … 10.0kHz / 12.5kHz (30 steps) | Removes the lowest frequencies from the effect signal. Higher keeps the bottom of your bass free from movement. |
| HIGH CUT | 20.0Hz / 25.0Hz / 31.5Hz / 40.0Hz … 12.5kHz / FLAT (30 steps) | Removes the highest frequencies from the effect signal. Lower makes the swirl darker and softer. |
| DIRECT LEVEL | 0 to 100 | The volume of your clean bass next to the effect. At 100 it stays complete, so your low end stays firm. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS CHORUS in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Modulation
Turn it yourself?
In GX Board, BASS CHORUS is a device in your rack, with all its controls on the front.