PAN

Moves the sound back and forth between the left and right side.

What it does

PAN moves your sound from left to right and back again. The sound walks through the stereo space, at the speed you choose.

You hear the effect properly only if you use a stereo output. With little DEPTH the movement is small, with a lot of DEPTH the tone goes from fully left to fully right.

How to use it

  • Set RATE slow and DEPTH medium for a soft, walking tone.
  • Set RATE to a note value such as 1/4 for a movement in the tempo of the song.
  • Set DEPTH high for a clear, striking effect.
  • Use it on a clean tone or a rhythm part to create space.

Where it goes in the chain

Usually after the amp and at the front of the stereo part of the chain, before delay and reverb, so the echoes move too.

Starting points

Walking tone

RATE 30 · DEPTH 50 · EFFECT LEVEL 100

A calm movement through the stereo space.

Left-right rhythm

RATE 1/4 · DEPTH 80 · EFFECT LEVEL 100

A clear switch in the tempo of your song.

Light space

RATE 20 · DEPTH 30 · DIRECT MIX 50

Subtle movement with a steady tone in the centre.

Every setting

SettingRangeWhat it does
RATE0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps)The speed of the movement: a number from 0 to 100, or a note value such as 1/4 or 1/8D, which follows the tempo (BPM) of the memory.
DEPTH0 to 100How far the tone travels left and right. Low stays near the centre, high goes to the outer edges.
WAVEFORM0 to 100Sets how the volume moves between left and right, from 0 to 100. Higher gives steeper waves and more abrupt switches, lower gives a softer movement.
EFFECT LEVEL0 to 100The volume of the effect. Keep it at 100 for an even volume, or adjust if the tone gets too quiet or too loud.
DIRECT MIX0 to 100The volume of the dry signal added to the mix. At 0 you hear only the effect, higher keeps your normal tone in the centre.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PAN in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, PAN is a device in your rack, with all its controls on the front.

Download for Mac