BASS FLANGER bass
Jet-plane swirl for bass, with your clean sound and low end kept in.
The version for guitar: FLANGER
What it does
A flanger blends in a very short delayed copy of your bass and moves it back and forth. That gives a hollow, sweeping sound like a jet passing overhead.
With DIRECT MIX and a LOW CUT you keep the lowest notes firm and let the sweep live mostly in the mids and highs.
How to use it
- Run RATE slowly with plenty of RESONANCE for a strong, metallic sweep in rock.
- Set DEPTH low and RESONANCE low for a soft swirl rather than an obvious jet.
- Use LOW CUT at 80Hz or higher, so the lowest fundamentals are not smeared.
- Use STEP RATE for a stepped, robotic effect.
Where it goes in the chain
Put it after compressor and drive and before delay and reverb. For an extra firm low end, keep DIRECT MIX higher.
Starting points
Soft jet
RATE 20 · DEPTH 50 · RESONANCE 30 · DIRECT MIX 40
A calm sweep where the low end stays firm.
Metallic and sharp
RATE 35 · DEPTH 70 · RESONANCE 70 · DIRECT MIX 50
A pronounced flanger for rock and funk.
Every setting
| Setting | Range | What it does |
|---|---|---|
| RATE | 0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps) | The speed of the sweep, free or as a note value. Slow is floating, fast is vibrating. |
| DEPTH | 0 to 100 | How far the sweep reaches. Low is subtle, high gives a big, clear movement. |
| RESONANCE | 0 to 100 | How much of the effect feeds back into itself. Higher sounds sharper and more metallic, lower softer. |
| MANUAL | 0 to 100 | The centre point the sweep moves around. Lower sounds deeper and more hollow, higher is brighter and thinner. |
| STEP RATE | OFF / 0 / 1 / 2 … 1/16T / 1/32 (120 steps) | Sets the cycle of a step function that changes the rate and depth. Higher gives finer steps. OFF switches it off. |
| EFFECT LEVEL | 0 to 100 | How much of the flanger sound you hear. Higher is more effect. |
| LOW CUT | FLAT / 20.0Hz / 25.0Hz / 31.5Hz … 10.0kHz / 12.5kHz (30 steps) | Removes the lowest frequencies from the effect signal. Higher leaves the bottom of your bass alone. |
| DIRECT MIX | 0 to 100 | Blends your clean bass in with the effect. Higher gives a firmer low end and a clearer attack. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS FLANGER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Modulation
Turn it yourself?
In GX Board, BASS FLANGER is a device in your rack, with all its controls on the front.