BOOSTER
Makes your signal stronger and pushes the amp harder.
What it does
The BOOSTER amplifies your signal and gives it a colour of its own. It raises the volume or adds some distortion. Use it to make the next effects or the amp work harder, or to push a solo forward.
TYPE chooses whether the boost favours the mids, stays neutral or adds extra top end.
How to use it
- Put it in front of a distorted amp for more gain and a thicker solo tone.
- Use CLEAN BOOST to make a clean sound louder without changing its tone.
- Choose MID BOOST to bring out a guitar with a lot of low end and top end in a band mix.
- Place it after another drive to make that drive sing a little more.
Where it goes in the chain
Usually first in the chain, before the drive or the amp, so they are driven harder. For plain extra volume, put it last.
Starting points
Clean push
TYPE CLEAN BOOST · BOOST 40 · TONE 0 · LEVEL 55
A slightly louder clean sound with the same tone.
Solo boost
TYPE MID BOOST · BOOST 70 · TONE 10 · LEVEL 60
A fuller, mid-rich sound that lets a solo cut through the band.
Bright and forward
TYPE TREBLE BOOST · BOOST 55 · TONE 15 · BOTTOM -10
A sharp boost for a dark amp.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | MID BOOST / CLEAN BOOST / TREBLE BOOST | MID BOOST stresses the mids and sits forward in the mix. CLEAN BOOST keeps the tone neutral. TREBLE BOOST makes the sound brighter and sharper. |
| BOOST | 0 to 120 | How much the signal is boosted and how much distortion comes with it. Low gives a small push, high drives the next drive or amp hard. Start around half way and listen. |
| TONE | -50 to 50 | Makes the sound darker (minus) or brighter (plus). Use it to fit the boost to your guitar and amp. |
| LEVEL | 0 to 100 | The volume of the effect. Set it so the sound is about as loud as with the effect off, or a little louder for a solo. |
| BOTTOM | -50 to 50 | More or less low end. Towards plus the sound gets fuller, towards minus tighter. Turn it back if it rumbles or turns muddy. |
| DIRECT MIX | 0 to 100 | Blends the untouched guitar signal in with the boosted sound. 0 is the effect only. More gives a more natural attack. |
| SOLO SW SOLO LEVEL | SOLO SW: OFF / ON SOLO LEVEL: 0 to 100 | SOLO SW switches to a tone that suits solos. SOLO LEVEL sets the volume while SOLO SW is on, so one switch brings your solo to the right level. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BOOSTER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, BOOSTER is a device in your rack, with all its controls on the front.