OVERDRIVE
Light, warm drive that follows how hard you play.
There is a version for bass too: BASS OVERDRIVE
What it does
The OVERDRIVE gives a light to medium distortion that moves with your picking. Play softly and the sound stays open, dig in and it growls. It suits blues, rock and a clean sound that needs a little extra bite.
TYPE chooses the character of the drive.
How to use it
- Use a low DRIVE for a clean sound that bites just a little more.
- Use it as a gentle push for an amp that already breaks up a little.
- Stack two drives: a light one with a high LEVEL for a full solo.
- Play chords with a medium DRIVE for a rough rock sound.
Where it goes in the chain
Usually before the amp, after the wah and the compressor. That way it drives the amp and the sound stays dynamic.
Starting points
Light blues bite
TYPE BLUES OD · DRIVE 30 · TONE 5 · LEVEL 55
A soft, open drive that mostly breaks up when you dig in.
Rock edge
TYPE CRUNCH · DRIVE 60 · TONE 0 · LEVEL 50 · BOTTOM -5
A rough rhythm sound for chords.
Singing solo
TYPE T-SCREAM · DRIVE 45 · TONE 10 · LEVEL 65
A drive with a higher LEVEL that brings the lead forward.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | NATURAL OD / WARM OD / BLUES OD / OD-1 / SD-1 / CRUNCH / T-SCREAM / TURBO OD / CENTA OD | NATURAL OD sounds natural, WARM OD warm. BLUES OD follows your picking closely. OD-1 is sweet and mild. CRUNCH adds amp-like grit. TURBO OD is high gain. SD-1, T-SCREAM and CENTA OD are other flavours. |
| DRIVE | 0 to 120 | How much distortion you hear. Low stays almost clean, high gets thick with long sustain. Turn it down if chords turn unclear. |
| TONE | -50 to 50 | Makes the sound darker (minus) or brighter (plus). Choose what suits your guitar and amp. |
| LEVEL | 0 to 100 | The volume of the effect. Set it as loud as with the effect off, or higher for a solo. |
| BOTTOM | -50 to 50 | More or less low end. Towards plus it gets fuller, towards minus tighter. Turn it back if it rumbles. |
| DIRECT MIX | 0 to 100 | Blends the untouched signal in with the distortion. More gives a clearer attack and less squash. 0 is distorted sound only. |
| SOLO SW SOLO LEVEL | SOLO SW: OFF / ON SOLO LEVEL: 0 to 100 | SOLO SW switches to a tone that suits solos. SOLO LEVEL sets the volume while SOLO SW is on, so one switch brings your solo to the right level. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. OVERDRIVE in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, OVERDRIVE is a device in your rack, with all its controls on the front.