DISTORTION
Firm, sustained distortion for rock and lead.
There is a version for bass too: BASS DISTORTION
What it does
The DISTORTION gives a firm, compact distortion with plenty of sustain. Chords sound full and notes hang on. It is tighter and more aggressive than an overdrive.
TYPE chooses the character: from rough and open to thick and full.
How to use it
- Play rhythm with power chords and a medium DRIVE.
- Raise DRIVE for long lead notes with lots of sustain.
- Use a low DRIVE for a raw, rough punk sound.
- Put it in front of a clean amp if you have no distortion of your own.
Where it goes in the chain
Usually before the amp, after the wah and the compressor. For a thicker sound you can put it in front of a clean channel.
Starting points
Power chord rhythm
TYPE DS-1 · DRIVE 55 · TONE 0 · LEVEL 50 · BOTTOM -10
A firm sound for chords.
Thick lead
TYPE LEAD DS · DRIVE 75 · TONE 5 · LEVEL 60
Plenty of sustain for long solo notes.
Raw punk
TYPE RAT · DRIVE 45 · TONE -5 · LEVEL 55
Rough, with a light attack.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | DIST / DS-1 / A-DIST / FAT DS / LEAD DS / RAT / GUV DS / DIST+ | DIST is a basic, traditional distortion. A-DIST gives fitting distortion from low to high notes. FAT DS is thick. LEAD DS is smooth like an overdrive yet deep. DS-1, RAT, GUV DS and DIST+ are other flavours. |
| DRIVE | 0 to 120 | How much distortion you hear. Low gives a gritty drive, high a thick, long sound. Turn it down if chords clog up. |
| TONE | -50 to 50 | Makes the sound darker (minus) or brighter (plus). Adjust it so the distortion does not turn harsh. |
| LEVEL | 0 to 100 | The volume of the effect. Set it as loud as with the effect off, or higher for a solo. |
| BOTTOM | -50 to 50 | More or less low end. Towards plus it gets fuller, towards minus tighter. Pull it back if it rumbles. |
| DIRECT MIX | 0 to 100 | Blends the untouched signal in with the distortion. More gives more attack and less squash. 0 is distorted sound only. |
| SOLO SW SOLO LEVEL | SOLO SW: OFF / ON SOLO LEVEL: 0 to 100 | SOLO SW switches to a tone that suits solos. SOLO LEVEL sets the volume while SOLO SW is on, so one switch brings your solo to the right level. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. DISTORTION in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, DISTORTION is a device in your rack, with all its controls on the front.