AIRD BASS PREAMP bass
A bass amp with speaker cabinet and mic, with your clean bass blended back in.
The version for guitar: AIRD PREAMP
What it does
This is a complete bass amp: preamp, tone controls, speaker cabinet and microphone in one block. You choose from nine amp models, from a natural clean sound to a growling, heavy drive.
DIRECT MIX blends your clean bass back in, so the lowest notes stay firm.
How to use it
- As the core of your bass sound when you go straight into a mixer or audio interface without a real amp.
- For a clean, round tone with NATURAL BASS or STUDIO BASS, or a thicker sound with SOLID STACK and FAT TUBE.
- Raise DIRECT MIX when drive makes the low notes thin: the clean bass holds the bottom end in place.
- Set SP TYPE to OFF when you send the output to a real bass amp or PA that already has its own cabinet.
Where it goes in the chain
Put it after your drives, compressor and wah, and before modulation and echo, the way a bass goes through an amp. It is usually the last block that shapes the tone.
Starting points
Natural and round
TYPE NATURAL BASS · GAIN 40 · BASS 55 · MIDDLE 50 · TREBLE 45
A clean, warm bass tone for fingerstyle and many styles.
Solid with bottom end
TYPE SOLID STACK · GAIN 70 · DIRECT MIX 40 · BASS 60
More push and colour while the clean bass keeps the lowest notes firm.
Dirty and dark
TYPE DARK DRV · GAIN 90 · DIRECT MIX 50 · TREBLE 40
A growling rock bass that stays in the mix.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | NATURAL BASS / X-DRIVE BASS / CONCERT / STUDIO BASS / SILVER TUBE / CLASSIC BLUE / SOLID STACK / FAT TUBE / DARK DRV | The amp model. NATURAL BASS is clean and uncoloured, X-DRIVE BASS is a wide high-gain sound. The other seven are amp voicings, from open to thick and dark. |
| GAIN | 0 to 120 | How much distortion the amp gives. Low stays clean, higher gives more grit. |
| SAG | -10 to 10 | Sets how much the compression changes in response to the power amp. It makes the amp feel more or less springy under your fingers. |
| RESONANCE | -10 to 10 | Sets how much the dynamics are affected by the interaction between the power amp and the speaker transformer. Set it by feel. |
| LEVEL | 0 to 100 | The volume of the whole preamp block. Do not set it too high. |
| BASS MIDDLE TREBLE | 0 to 100 | The three tone controls. BASS sets depth, MIDDLE sets punch and how the bass cuts through the mix, TREBLE sets attack and brightness. |
| PRESENCE | 0 to 100 | Shapes the tone in the extended upper range. Keep it low if your bass is already bright. |
| BRIGHT SW | OFF / ON | Turns the bright setting on or off. It only works with some TYPE choices. |
| GAIN SW | LOW / MIDDLE / HIGH | Picks one of three distortion levels: LOW, MIDDLE and HIGH. Each step distorts more. Every TYPE is voiced with MIDDLE. |
| SOLO SW | OFF / ON | Switches to a tone that suits solos. You set its volume with SOLO LEVEL. |
| SOLO LEVEL | 0 to 100 | The volume while SOLO SW is on. Higher gives more lift for a solo. |
| SP TYPE | OFF / ORIGINAL / 1x8" / 1x10" … USER 15 / USER 16 (30 steps) | The speaker cabinet. OFF switches the simulation off, ORIGINAL is the built-in speaker of the chosen amp model. Then small open cabinets, big closed ones, double stacks and 16 USER slots for your own IR data. |
| DIRECT MIX | 0 to 100 | The volume of the direct sound. Higher gives a firmer low end at high gain. At 0 you hear only the amp. |
| MIC TYPE | DYN57 / DYN421 / CND451 / CND87 / RBN121 / BLEND A / BLEND B / BLEND C / FLAT | The mic on the cabinet. DYN57 is a general dynamic mic, DYN421 a dynamic with extended lows, CND451 and CND87 are condenser mics, RBN121 is a warm ribbon mic. BLEND A to C mix mics, FLAT is flat. |
| MIC DISTANCE | SHORT / MEDIUM / LONG | The distance between mic and speaker. The distance grows in the order SHORT, MEDIUM, LONG. |
| MIC POSITION | CENTER / 1cm / 2cm / 3cm / 4cm / 5cm / 6cm / 7cm / 8cm / 9cm / 10cm | Where the mic sits in front of the speaker. CENTER is the middle of the speaker cone, 1cm to 10cm moves the mic further from the centre. |
| MIC LEVEL | 0 to 100 | The volume of the mic in the sound. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. AIRD BASS PREAMP in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Amp
Turn it yourself?
In GX Board, AIRD BASS PREAMP is a device in your rack, with all its controls on the front.