ANALOG DELAY
An echo with a mild, analog sound.
What it does
ANALOG DELAY gives an echo with a mild, analog sound. The repeats sit behind your playing in the mix.
The shortest time is 12 ms. Modulation gives the echo a slight waver, and ducking lowers it while you play.
How to use it
- Set a medium TIME with little FEEDBACK for a warm echo that gives your solo space without blurring it.
- Add a little MOD DEPTH for an echo that drifts lightly.
- Set FEEDBACK high for floating, building repeats and play a simple motif through them.
- Use ducking for fast riffs: the echo steps back while you play and returns when you stop.
Where it goes in the chain
After the drive and before the reverb, or after the amp in the effects loop. The warm repeats then add to your sound without clouding it.
Starting points
Warm solo
TIME 380ms · FEEDBACK 30 · EFFECT LEVEL 45 · HIGH CUT 5.00kHz
A warm echo that gives your solo space without blurring it.
Floating echo
TIME 500ms · FEEDBACK 55 · EFFECT LEVEL 50 · MOD RATE 30 · MOD DEPTH 25
Repeats that waver lightly and drift away slowly.
Short thickness
TIME 90ms · FEEDBACK 15 · EFFECT LEVEL 40
A short, soft echo that makes your playing a little wider.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | MONO / DIR/EFX | MONO is a plain echo. DIR/EFX separates your dry signal from the echo, handy when you want to route or mix them apart. |
| TIME | 12ms / 13ms / 14ms / 15ms … 1/1D / 2/1 (1207 steps) | The time between repeats, from 12 ms, in milliseconds or as a note value such as 1/4 or 1/8D. A note value follows the tempo (BPM) of the memory. |
| FEEDBACK | 0 to 100 | How much of the echo comes back. Low gives a few repeats, high a long tail. |
| EFFECT LEVEL | 0 to 120 | The volume of the echoes. Start around 40 to 50 and choose what fits your playing. |
| DIRECT LEVEL | 0 to 100 | The volume of your dry signal. At 100 your guitar stays as it was. |
| HIGH CUT | 20.0Hz / 25.0Hz / 31.5Hz / 40.0Hz … 12.5kHz / FLAT (30 steps) | Cuts the high end of the echoes. FLAT lets everything through; lower gives even darker repeats. |
| MOD RATE MOD DEPTH | 0 to 100 | Makes the echoes waver lightly. RATE is the speed, DEPTH the amount. At DEPTH 0 you hear nothing; small values sound warm and alive. |
| DUCK SENS | 0 to 100 | How sensitive the ducking is to your playing. Higher means the echo steps back sooner. |
| DUCK PRE | 0 to 100 | Turns down the signal going into the echo while you play loudly. Closer to 100 gives a stronger reduction. |
| DUCK POST | 0 to 100 | Turns down the output of the echo while you play loudly. Closer to 100 gives a deeper reduction. |
| CARRYOVER | OFF / ON | ON lets the echoes ring out after you switch the effect off. OFF cuts them off at once. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. ANALOG DELAY in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Echo
Turn it yourself?
In GX Board, ANALOG DELAY is a device in your rack, with all its controls on the front.