PARAMETRIC EQUALIZER
A precise equalizer where you choose the frequency and the width yourself.
What it does
The parametric equalizer lets you choose two mid bands: where they sit, how wide they are and how much they boost or cut. There is also a low and a high control and two filters.
That lets you remove a troublesome tone or shape a sound exactly.
How to use it
- Remove a harsh or boomy tone with a narrow, cut band.
- Raise a wide band in the mids to bring a solo forward.
- Use LOW CUT to remove hum and rumble in the bottom end.
- Use HIGH CUT to tame sharp hiss on top, especially with a lot of gain.
Where it goes in the chain
Put it after the amp for the final tone, or before it to shape the distortion.
Starting points
Mids forward
LOW-MID Q 1 · LOW-MID GAIN 4 · HIGH-MID Q 1 · HIGH-MID GAIN 2
A wide lift in the mids so your solos stand out.
Remove a tone
HIGH-MID Q 8 · HIGH-MID GAIN -8
A narrow dip to remove a sharp or boomy tone.
Tidy
LOW GAIN -3 · HIGH GAIN -2 · LEVEL 2
Keeps the ends of the tone clean.
Every setting
| Setting | Range | What it does |
|---|---|---|
| LOW GAIN HIGH GAIN | -20 to 20 | Raise or lower the lowest and highest tones as a whole. For quickly more or less bass and treble. |
| LEVEL | -20 to 20 | The overall volume after the equalizer. Use it to keep the volume the same when you boost bands. |
| LOW-MID FREQ HIGH-MID FREQ | 20.0Hz / 25.0Hz / 31.5Hz / 40.0Hz … 10.0kHz / 12.5kHz (29 steps) | The frequency where the mid band sits. Low is the lower mids, high the upper mids. Use a strong GAIN to find where your tone lacks or has too much. |
| LOW-MID Q HIGH-MID Q | 0.5 / 1 / 2 / 4 / 8 / 16 | The width of the band. Low values are wide and gentle, high values narrow and precise, handy for removing a single tone. |
| LOW-MID GAIN HIGH-MID GAIN | -20 to 20 | How much the band boosts (positive) or cuts (negative). At 0 the band does nothing. |
| LOW CUT | FLAT / 20.0Hz / 25.0Hz / 31.5Hz … 10.0kHz / 12.5kHz (30 steps) | Cuts the tones below this frequency. FLAT lets everything through, higher cuts more low end against hum and mud. |
| HIGH CUT | 20.0Hz / 25.0Hz / 31.5Hz / 40.0Hz … 12.5kHz / FLAT (30 steps) | Cuts the tones above this frequency. FLAT lets everything through, lower makes the tone darker and removes hiss. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PARAMETRIC EQUALIZER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in EQ
Turn it yourself?
In GX Board, PARAMETRIC EQUALIZER is a device in your rack, with all its controls on the front.