GRAPHIC EQUALIZER

Ten sliders to raise or lower the sound band by band.

What it does

The graphic equalizer splits the sound into ten bands, from deep lows to highs. For each band you turn the volume up or down.

That lets you shape a tone with a few clear moves, for example more low end, less dull mids or more air.

How to use it

  • Take out some dull mids with 250Hz and 500Hz to open up a tone.
  • Lift the high bands slightly for more air and sparkle.
  • Cut the low bands back if your tone is too thick or boomy.
  • Make a shape with the sliders for a hollow or a sharp tone and tune it to the room.

Where it goes in the chain

Put it after the amp for the final tone. Before the amp it shapes what goes into the distortion.

Starting points

Open and bright

250Hz -4 · 2kHz 3 · 8kHz 4 · 16kHz 3

Removes some dullness and gives the tone more air.

Warm

125Hz 3 · 4kHz -3 · 8kHz -4

A softer, rounder tone.

Lead up front

500Hz 3 · 1kHz 4 · 2kHz 2 · LEVEL 2

More mids so your solos stand out above the band.

Every setting

SettingRangeWhat it does
31.5Hz
63Hz
-20 to 20The deepest lows. More gives thump and weight, less removes rumble and hum.
125Hz
250Hz
-20 to 20The lower body of the guitar. More makes the tone full, too much makes it muddy.
500Hz
1kHz
-20 to 20The mids, where the guitar makes itself heard. More gives presence, less a hollow tone.
2kHz
4kHz
-20 to 20The bite and brightness of the pick attack. More makes the tone sharp and cutting, less softer.
8kHz
16kHz
-20 to 20Air and shine. More makes the tone open and fine, less removes sharp hiss.
LEVEL-20 to 20The overall volume after the equalizer. Use it to keep the volume the same when you raise or lower bands.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. GRAPHIC EQUALIZER in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, GRAPHIC EQUALIZER is a device in your rack, with all its controls on the front.

Download for Mac