MIXER

Joins the two channels of the DIVIDER again.

What it does

MIXER joins the two channels A and B that the DIVIDER made back into one sound. You set the volume of each channel and decide how they spread across left and right.

You can also delay channel B slightly for a more spacious sound.

How to use it

  • Set A LEVEL and B LEVEL to blend the two channels in the right ratio.
  • Use A/B BALANCE to bring one channel forward and the other back.
  • Choose PAN L/R to put channel A on the left and channel B on the right.
  • Raise SPREAD to delay channel B a little for a more spacious sound.

Where it goes in the chain

Put MIXER at the point where the two channels come together again, after the effects of channel A and B.

Starting points

Equal mix

MODE STEREO · A LEVEL 100 · B LEVEL 100 · SPREAD 0

Both channels equally strong, mixed in stereo.

Left and right

MODE PAN L/R · A LEVEL 100 · B LEVEL 100

Channel A on the left and channel B on the right, for a wide sound.

Every setting

SettingRangeWhat it does
MODESTEREO / PAN L/RSTEREO mixes channels A and B in stereo. PAN L/R sends channel A to the left output and channel B to the right output.
A LEVEL
B LEVEL
0 to 100Volume of channel A and channel B. Set them so the two sounds are in good balance.
A/B BALANCE100:0 / 100:2 / 100:4 / 100:6 … 2:100 / 0:100 (101 steps)The volume balance between A and B, from 100:0 (only A) to 0:100 (only B). Only shown when DIVIDER MODE is DUAL.
SPREAD0 to 100Delays channel B slightly for a more spacious sound. Only shown in DUAL. Low is compact, high is more spacious.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. MIXER in the BOSS Parameter Guide · GX-100 manuals at BOSS

More in Routing and looper

Turn it yourself?

In GX Board, MIXER is a device in your rack, with all its controls on the front.

Download for Mac